5-way chandelier does not turn on correctly after replacement
Good afternoon. After installing a new chandelier by an electrician, the sequence of its work changed. 5 shades, 2-button switch. When you press the first button separately, five shades light up. When you press the second button separately, 3 lights turn on. When both buttons are pressed, 2 plafonds are turned off and those 3 plafonds that work from the second button burn slightly brighter.
There are three wires from the chandelier. The chandelier itself is connected inside - 5 wires, one from each lampshade connected together, apparently this is zero. 3 wires are connected and this is the second output wire. 2 wires are connected and this is the third wire coming out of the chandelier.
There are three wires from the chandelier. The chandelier itself is connected inside - 5 wires, one from each lampshade connected together, apparently this is zero. 3 wires are connected and this is the second output wire. 2 wires are connected and this is the third wire coming out of the chandelier.
As I understand it, shunting occurs when two buttons are turned on. Is it dangerous? And how can I redo it? LED lamps in the chandelier
Hello! I would disconnect the chandelier in your place, disassemble all the connections from the cartridges to separate wires and reconnect them, then reconnect and check. It is very difficult to judge, you clearly explained what the problem was, but that didn’t make it easier. Previously, there was also a chandelier in which the plafonds were divided into 2 groups and everything worked fine? If so, then the problem is connecting the chandelier. Somewhere messed up the ends. Perhaps some lamps turned out to be connected in series (which is exactly what the description of your problem looks like).
Loading...