How to connect a massager without a battery from the adapter?

Hello! How to connect a massager without a battery from the adapter? Connect to the terminals where the battery was? Connecting to the standard jack, it does not work. The adapter produces 2.8v 500ma. On the battery 2.4v130me. Would it burn? There is no way to buy a battery, but the wire does not hurt.

Loading...

13 comments

  • Admin

    Hello! Yes, connect to the terminals to which the battery was connected. And the fact that the voltage is slightly higher is not too scary. On the battery, not 130 mA, but 130 mA / h, the difference is big, because capacity and current output are two different things. And secondly - the load itself takes its current which it needs, i.e. if the PSU is 500 mA, then this does not mean that all 500 mA will go to the massager, and at the same time does not mean that such a current of the power source is enough. Check empirically.

    To answer
  • Vladimir

    You're right! 130ma / h Please tell me (if you can) the parameters of the power supply unit that replaces the battery. At least approximate.

    To answer
    • Admin

      I think that your power supply should also work, if this is such a massager, which I assume, then it consumes a little. How long was your battery? So you can indirectly determine the current consumption.

      To answer
  • Vladimir

    I have a XINGMA PSU (China) It is from 3-12V, 500ma. Can I connect it directly? And what voltage to expose? I'm just afraid that it will burn. There is still the same PSU, but at 1000ma. Which is better?

    To answer
    • Admin

      You say there is a native adapter? Try to start it. And then if something goes wrong, try applying 3 volts from that 1000 mA PSU

      To answer
  • Vladimir

    The fact of the matter is that there is no native. And how many volts and amperes can be increased?

    To answer
  • Vladimir

    A fully charged battery lasted for 30 minutes.

    To answer
  • Vladimir

    Here it is.

    To answer
    • Admin

      I already answered you everything, that it is necessary to try. The ampere massager itself will take as much as needed, the more volts you supply, the faster it will work and the more it will consume Ampere. Supply a very high voltage - the engine will burn. Does your PSU have a minimum of 3V? Here and submit them. At the same time, check how the device works and whether it is warming up.

      To answer
  • Vladimir

    I will try!

    To answer
  • Vladimir

    Hello! On the PSU, which is regulated by 3-12V, set 3V, and checked by the tester it shows 5.5V. If I connect the massager will not burn?

    To answer
    • Admin

      Without load, they all show this, if you are very worried, connect a 50 ohm resistor. As a result, the current will be 100 mA and you will see the voltage under load.

      To answer
  • Vladimir

    And if you connect via a car bulb, in series?

    To answer

Add a comment