How to connect a switch to an electric convector OPti HNC - 2002?

Hello! If there was a switch of 6 contacts in 2 rows (i.e. 3 + 3), then 90% of the probability that the purpose of the contacts in it is similar to that which failed. Usually this is a two or three position switch. Middle contacts - this is the "entrance", the extreme "exit" of each position. Vertical - these are two groups of contacts, i.e. vertical stripes do not interconnect. Vertically, on one side, the upper and the middle are connected, the lower and the middle.

If the switch had three positions (ON1-OFF-ON2), then in the middle position the middle contacts didn’t close with anything, in the upper one the middle contacts closed with the lower ones, in the lower one the middle ones closed with the upper ones. If there were two positions, then everything is also but without the middle position “OFF”, i.e. switched either middle with upper or middle with lower.

What numbering of contacts on the new I and deep down cannot imagine, it can be any. Either vertically 1-2-3 in the first column, and 4-5-6 in the second, or vertically 1-3-5, 2-4-6 ... I described the essence of this switch - the wires coming to it to the middle contacts - going to the heating elements - to the extreme contacts. I hope you remember how it was connected before - connect as it was.

If I have not fully answered your request, please clarify your question. Successful connection, I think that everything will be as I wrote above.